Page 1 of 1

normal compilation but Constraints not satisfied

Posted: Mon May 14, 2018 5:13 pm
by sarahazzam
HI,

I run a minlp model on baron solver but the results don't satisfy a constraint while the outpu message is normal compilation. how to set the constraint tolerance to zero?

Re: normal compilation but Constraints not satisfied

Posted: Wed Dec 18, 2019 1:39 pm
by bussieck
"Normal completion" is the solver status code. You need to look at the model status. Infeasible or unbounded are also very fine model status codes in optimization. Perhaps BARON found your model to be infeasible.

-Michael