Hi
I am using Studio 17.3.
If I search for an item in one file, and then go to another file (leaving the search dialogue open) and search again, it takes me back to the original file.
Although I noticed this Studio 17.2, I don't recall it happening in earlier versions.
It does not matter whether the files are in the same or different projects.
I may be missing something, but it is a little irritating having to close the Search dialogue and reopen to search for the same item. I often search for something in the .lst file to find which include it is in, and then go to the include.
Best
Rob
Search in Studio
Re: Search in Studio
Rob,
Thanks for reporting this! This is a bug. As a workaround, you should be able to use "Search all" (`Shift+Enter` in the dialog), which should not have the same problem.
But in any case: This is on our list to be fixed.
Best,
Lutz
Thanks for reporting this! This is a bug. As a workaround, you should be able to use "Search all" (`Shift+Enter` in the dialog), which should not have the same problem.
But in any case: This is on our list to be fixed.
Best,
Lutz
-
- User
- Posts: 25
- Joined: 3 years ago
Re: Search in Studio
Thanks as usual, Fritz.
I have also noticed that when I am at the top of the list file and do a search, the first thing it jumps to is wrong. After that it is fine.
For example I search for "TAXPAR" and it first highlights QX.
I have tried attaching the list file here but am unable to.
Best
Rob
I have also noticed that when I am at the top of the list file and do a search, the first thing it jumps to is wrong. After that it is fine.
For example I search for "TAXPAR" and it first highlights QX.
I have tried attaching the list file here but am unable to.
Best
Rob
-
- User
- Posts: 25
- Joined: 3 years ago
Re: Search in Studio
Following on from the above problem.
I am using search and replace. The search still finds the wrong thing, but now in all of the files, not just the lst file.
I also notice that it tells me at the start there are, say, 5 matches found, but when I replace the first one, it still indicates 5 remaining, and after replacing all, it indicates there is 1 match remaining.
Trivial, but clearly a bug. I am scared to use replace all, since it may replace the wrong thing.
Best
Rob
I am using search and replace. The search still finds the wrong thing, but now in all of the files, not just the lst file.
I also notice that it tells me at the start there are, say, 5 matches found, but when I replace the first one, it still indicates 5 remaining, and after replacing all, it indicates there is 1 match remaining.
Trivial, but clearly a bug. I am scared to use replace all, since it may replace the wrong thing.
Best
Rob
Re: Search in Studio
Rob,
Thanks again for the report! Would it be possible, that you send an example of this to support@gams.com?
Just two days ago, I discovered, that the replace action works correctly, but the find afterwards still reports the old results (though, they were replaced correctly), if I use use "This project" as serach scope. That problem does not happenn, if I do a replace in a single file. I am not sure, if that is actually the same, you ran into.
Best regards,
Lutz
Thanks again for the report! Would it be possible, that you send an example of this to support@gams.com?
Just two days ago, I discovered, that the replace action works correctly, but the find afterwards still reports the old results (though, they were replaced correctly), if I use use "This project" as serach scope. That problem does not happenn, if I do a replace in a single file. I am not sure, if that is actually the same, you ran into.
Best regards,
Lutz