Studio runs when first opened but then gives an error
Posted: Wed Jul 19, 2023 1:18 pm
When I run a model in Studio after I have just opened it the process log shows normal completion.
But when I next run it I get the error message:
gams: **** Error: Parameter error(s)
: Reading parameter(s) from "command line"
: *** Error Cannot open parameter file "."
: *** Error Error code = 13; Permission denied
: Finished reading from "command line"
: *** Error command line = I "C:\Users\Rob Davies\Downloads\D-drive\AMODELS\IFPRI-Standard-CGE-2-1\1CGEmod2-1.gms" logoption=3 ide=1 errorlog=99 errmsg=1 pagesize=0 lstTitleleftaligned=1 pf="."
If I close and reopen, I can run it once.
Rob
But when I next run it I get the error message:
gams: **** Error: Parameter error(s)
: Reading parameter(s) from "command line"
: *** Error Cannot open parameter file "."
: *** Error Error code = 13; Permission denied
: Finished reading from "command line"
: *** Error command line = I "C:\Users\Rob Davies\Downloads\D-drive\AMODELS\IFPRI-Standard-CGE-2-1\1CGEmod2-1.gms" logoption=3 ide=1 errorlog=99 errmsg=1 pagesize=0 lstTitleleftaligned=1 pf="."
If I close and reopen, I can run it once.
Rob